MasterEmaco T 545 and T 545HT
Very rapid-setting chemical action mortar
How does MasterEmaco T 545 and T 545HT work?
MasterEmaco T 545 is a one-component magnesium phosphate-based mortar. Offered in two formulations: T 545 for ambient and substrate temperatures below 85° F (29° C) and T 545HT for ambient and substrate temperatures ranging from 85 to 100° F (29 to 38° C).
Recommended uses:
- Interior and exterior
- Horizontal and formed vertical overhead repairs
- Applications requiring high early-strength gain
- Structural concrete repairs
- Partial and full-depth repairs
- Cold temperature repairs
- Grouting applications such as anchor bolts, rebar, dowel rods and precast applications
What are the unique features of MasterEmaco T 545 and T 545HT?
- Single component to just add water and mix
- Takes rubber tire traffic in 45 minutes
- Wide temperature use range from below freezing to hot weather exposures
- Air cure only, no wet curing compounds required
- Coefficient of thermal expansion similar to Portland cement concrete for more permanent repairs
- Higher sulfate resistance than conventional mortars
What are the benefits of MasterEmaco T 545 and T 545HT?
- Reaches 2,000 psi compressive strength in 1 hour to rapidly return repairs to service
- Very low drying shrinkage for improved bond to concrete for repair and anchoring applications
- Resistant to freeze/thaw cycles and deicing chemicals so it is usable in most environments
On the Job Videos
Direct contact
Related Literature
Certification Letter
pdf
(89.79 Kb)
Data Guide
pdf
(180.85 Kb)
Data Guide (French)
pdf
(378.68 Kb)